1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
|
{{/*
# Copyright © 2018 AT&T, Amdocs, Bell Canada Intellectual Property. All rights reserved.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*/}}
filebeat.prospectors:
#it is mandatory, in our case it's log
- input_type: log
#This is the canolical path as mentioned in logback.xml, *.* means it will monitor all files in the directory.
paths:
- /var/log/onap/*/*/*/*.log
- /var/log/onap/*/*/*.log
- /var/log/onap/*/*.log
#Files older than this should be ignored.In our case it will be 48 hours i.e. 2 days. It is a helping flag for clean_inactive
ignore_older: 48h
# Remove the registry entry for a file that is more than the specified time. In our case it will be 96 hours, i.e. 4 days. It will help to keep registry records with in limit
clean_inactive: 96h
# Name of the registry file. If a relative path is used, it is considered relative to the
# data path. Else full qualified file name.
#filebeat.registry_file: ${path.data}/registry
output.logstash:
#List of logstash server ip addresses with port number.
#But, in our case, this will be the loadbalancer IP address.
#For the below property to work the loadbalancer or logstash should expose 5044 port to listen the filebeat events or port in the property should be changed appropriately.
hosts: ["{{.Values.config.log.logstashServiceName}}:{{.Values.config.log.logstashPort}}"]
#If enable will do load balancing among availabe Logstash, automatically.
loadbalance: true
#The list of root certificates for server verifications.
#If certificate_authorities is empty or not set, the trusted
#certificate authorities of the host system are used.
#ssl.certificate_authorities: $ssl.certificate_authorities
#The path to the certificate for SSL client authentication. If the certificate is not specified,
#client authentication is not available.
#ssl.certificate: $ssl.certificate
#The client certificate key used for client authentication.
#ssl.key: $ssl.key
#The passphrase used to decrypt an encrypted key stored in the configured key file
#ssl.key_passphrase: $ssl.key_passphrase
|
