.. This work is licensed under a Creative Commons Attribution 4.0 International License. .. http://creativecommons.org/licenses/by/4.0 Installation ============ To run VES Collector container on standalone mode, following parameters are required ``docker run -d -p 8080:8080/tcp -p 8443:8443/tcp -P -e DMAAPHOST='10.0.11.1' nexus.onap.org:10001/onap/org.onap.dcaegen2.collectors.ves.vescollector:1.3.2`` DMAAPHOST is required for standalone; for normal platform installed instance the publish URL are obtained from Consul. Below parameters are exposed for DCAE platform (cloudify) deployed instance - COLLECTOR_IP - DMAAPHOST - should contain an address to DMaaP, so that event publishing can work - CBSPOLLTIMER - it should be put in here if we want to automatically fetch configuration from CBS. - CONSUL_PROTOCOL - Consul protocol by default set to **http**, if it is need to change it then that can be set to different value - CONSUL_HOST - used with conjunction with CBSPOLLTIMER, should be a host address (without port! e.g my-ip-or-host) where Consul service lies - CBS_PROTOCOL - Config Binding Service protocol by default set to **http**, if it is need to change it then that can be set to different value - CONFIG_BINDING_SERVICE - used with conjunction with CBSPOLLTIMER, should be a name of CBS as it is registered in Consul - HOSTNAME - used with conjunction with CBSPOLLTIMER, should be a name of VESCollector application as it is registered in CBS catalog These parameters can be configured either by passing command line option during `docker run` call or by specifying environment variables named after command line option name